Introduction
Here’s the thing: we built this electric heater with one clear goal in mind. Give you serious, industrial-strength infrared heat—without wrecking the planet in the process. From the very first piece of material to the final assembly, we kept things clean. And we built this thing to last. What you get is a halogen infrared lamp, designed to blast out concentrated warmth right where you need it. It’s perfect for spot heating or process work, especially when you need heat fast and don’t have a lot of space to spare.
The Tech, Without the Fluff
We set this heater up as a 400V system. Why? Because most factory lines are already wired for 400V three-phase. So you can just plug it in, no extra transformers needed. This also means the current is lower for the same wattage, which keeps the wiring simpler and puts less strain on your connections. The lamp itself is a 300mm tube. That size lets it slide into tight spots—narrow channels, small enclosures, compact heating modules. We matched the wattage to the tube length to pack in serious heat, but not so much that it burns the element out. The goal was power and longevity, not a quick burnout.
What It’s Built From
Inside the quartz tube, you’ll find a halogen element. Quartz was the obvious choice because it can handle the shock of turning on and off again and again, and it stays rock-solid at those scorching filament temperatures. The halogen cycle keeps the element clean as it runs, so the heat output stays strong over time. We also coated the tube to focus the energy where you want it—strong infrared, less of that harsh, unwanted glare. And for the connections, we went with an R7s connector. It’s a standard, tough two-pin setup that’s quick to install and can take the constant vibration of a busy factory floor.
Who It’s For, and What It Feels Like
This is for engineers who need a heating module they can drop in and forget about. Seriously. It integrates fast, and when it’s time for a replacement, the downtime is minimal. That 300mm size and the R7s connection make mounting and wiring a breeze. You can slot it right into existing fixtures without having to redesign the whole assembly. It heats up fast—really fast. But that power means you need to plan for it. Make sure the parts around it can handle the local heat, and get your shielding and cooling sorted. And from start to finish, we’re committed to building this thing responsibly. We control contaminants early on and keep waste to a minimum during assembly. The result? A budget-friendly heater that doesn’t cut corners on the performance or reliability your work demands.